Exterior reflective window film on a mall skylight in Al Ain, UAE

Case Study: Barari Outlet Mall Skylight, Al Ain – 183 to 16 W/m²

November 17, 2026

In short: At Barari Outlet Mall in Al Ain, the skylight glass was letting in 183 W/m² of solar heat. With Global Reflective Silver 15 Exterior (RS 15X) film on the outside of the glass, the reading through the glass dropped to 16–17 W/m² – a cut of about 90%. Both readings were taken on site with an EDTM SP2065 solar power (BTU) meter.

The problem: a hot skylight over a busy mall

Large skylights bring daylight into a mall, but in Al Ain they also bring in a lot of heat. Heat that comes through overhead glass falls straight onto shoppers and walkways, and the air-conditioning has to work hard to remove it. The mall wanted to reduce the heat without blocking the skylight or replacing the glass.

The film we used

We chose Global Reflective Silver 15 Exterior (RS 15X), applied to the outside of the skylight glass. Exterior film stops the sun's heat before it enters the glass, which matters on skylights and double-glazed units where interior film can trap heat in the glass. According to the Global technical data sheet, RS 15X has:

  • Visible light transmission: 14%
  • Total solar energy rejected (TSER): 85%
  • UV rejection: over 99%

See the full figures in our Global window film specification table.

How we measured it

We used an EDTM SP2065 solar power meter, which reads the solar energy passing through glass in watts per square metre (W/m²). We took a reading through the existing skylight glass, then a reading through glass with RS 15X film, at the same place and time.

ReadingSolar heat through the glass
Existing skylight glass183 W/m²
With Reflective Silver 15 Exterior film16–17 W/m²
Reductionabout 90%

A spot reading is not the same as a full-year energy study. Actual AC savings depend on the skylight area, orientation, glass type and how the building is cooled. We can prepare an energy and payback estimate for your own building.

What this means for other buildings

  • Malls, atriums and showrooms: skylights are often the largest single source of heat. Exterior film is usually the right choice.
  • Villas with skylights or roof glass: the same film works on smaller domestic skylights.
  • Look and light: RS 15X gives a mirror look from outside and lets about 14% of visible light through, so the space stays bright but much less hot.

Read more in our skylight window film guide, our Al Ain window film page and our commercial window film service.

FAQ

How much heat does skylight film block?

On the Barari Outlet Mall skylight, Reflective Silver 15 Exterior reduced the heat through the glass from 183 W/m² to 16–17 W/m², about 90%. Results vary with glass type and film choice.

Should skylight film go inside or outside?

For most UAE skylights, outside. Exterior film rejects heat before it enters the glass and avoids heat stress on double-glazed or laminated skylight units.

Can you measure my building before installing?

Yes. We can take solar meter readings on your glass during a free site survey and show the difference with a film sample.

Get a free skylight survey: WhatsApp photos of your skylight to +971 56 702 7879, email [email protected] or book a site visit.

Back to Blog